Lubin 12 is water and moisture repellent, designed to protect and lubricate in all weather conditions. A better lubricant will reduce heat/ friction, which lessens wear and tear on parts and improves performance. Lubin 12 can be used on open and closed axle bearings, ball joints, stub axle bearings and front wheel bearings all the while protecting parts from corrosion.
 
 

LUBIN 12 A PRODUCT THAT WORKS IN ALL BEARING AVIALABLE ONLY IN A AEROSOL CANS
SHAKE THE CAN WELL AS IT HAS ACTIVE INCREDIENTS THAT NEED TO BE ACTIVATED BY VIGEROUS MOVEMENT
POINT THE CAN INTO THE REAR AXLE BEARINGS APPROX. 100-150mm AND COAT THEM LIBERALLY.
DO ALL THREE BEARINGS EACH TIME
WIPE OFF THE ACCESS OVER SPRAY WITH A DRY CLEAN CLOTH USING SPEED CLEAN IF NECCESARY
STUB AXLES ALSO HAVE BEARINGS JUST A QUICK SQIURT IS ALL THATS REQIURED
A QUICK SQIURT ON THE WHEEL BEARINGS IS ALL THAT IS REQIURED AS TOO MUCH WILL OVER SPILL ONTO THE RUBBER OF THE WHEEL.
A QUICK SQIURT ON THE STEERING COLUMN BEARINGS AND THE TIE RODS IS ALL THAT IS REQIURED.
A QUICK SQIURT ON THE TIE ROD END BEARINGS IS ALL THAT IS REQIURED.
WIPE OFF THE ACCESS OVER SPRAY WITH A DRY CLEAN CLOTH USING SPEED CLEAN IF NECCESARY
WHEN YOU HAVE THE TYRE OFF THE RIM IS A GOOD TIME TO THROUGHLY SOAK THE BEARING IN SPEED CLEAN THEN APPLY THE LUBIN
DONT FORGET THAT THERE ARE EARINGS ON BOTH SIDES
WHEN THE STUB AXLES ARE OUT THIS IS A GOOD TIME TO THROUGHLY CLEAN THE BEARINGS WITH SPEED CLEAN AND THEN TREAT THEM WITH LUBIN
 
   
   
   
   
 
 
TOP OF PAGE ..........................GO TO NEXT PRODUCT..............................HOME